Author Topic: Triumph Tiger 800 XRx Bullet installation.  (Read 4359 times)


  • BikeVis Owner
  • Administrator
  • Hero Member
  • *****
  • Posts: 1577
Triumph Tiger 800 XRx Bullet installation.
« on: November 07, 2016, 05:54:57 AM »
Mike sent over a guide to fitting our Bullet lights on his Triumph Tiger 800 XRx. He also fitted our PodMod modulator. Many thanks.

Fit the lights on the top face of the two black inner side panels, below the headlight.
Remove the two screws on each panel so as to pull it back to enable cable routing.
Determine position and drill required hole upwards through plastic panel.
Find headlight relay under seat, It should be the left hand one on the front row.
Ease all relays out of there rubber holders for ease of getting at the wires on the underside of the relay socket.
It should be the second large wire in from the left that feeds the headlight.
Using an inline cable connector join an inline fuse holder to it.
I mounted the modulator under the cross bar below the seat.
Connect the modulator, fuse & earth locally under seat as wiring instructions.
I used a length of two core cable to feed the  + & -.forwards to the led Bullets. Just easier.
Finally diverting the cable into two feeding left and right LED's