Honda ST1300A Pan European - Rear Facing Red and Front Facing White Side Lights

Started by rkjm, April 06, 2017, 02:44:51 PM

Previous topic - Next topic

rkjm

The rear facing red LED's were mounted on each side of the upper face of the rear light cluster fairing. A wiring tap of the right-hand side tail light (looking from the rear) was fed up into the rear fairing area, using the same routing as the rear light cable. The new tail light feed was connected to a modulator unit (to allow rear light & brake light functionality) via crimp connectors and then to the individual red LED's, again via crimp connectors. A small drilled hole was used to pass the cable through and in addition to the LED's sticky base a small amount of clear silicone was used to seal the hole.

The front side lights were a straight swap.

Simples!










Fluke