Cree V3 - 2007 Versys Installation

[mark206000]

Cree v3 wide angles on a 2007 Versys. 


SWMotech 27mm brackets to fit the H&B crash bars



Took the brackets of the lights.  Attached them direct the the new brackets.  One nut needed a few mm taken of with a dremel


Bracket fitted on crash bar.  Few rubber shims around it and one when the light attaches incase it tries to move







Heat shrink on the loose wires of the loom to protect them and keep then neat


New switch on handlebars to be wired in


Lights and switch wired back through.  Few bits of trim removed, wires cable tied to main loom along side of tank


Little 4 way fuse box fitted.  Bit of, crimping and testing


All wired in of a relay


All looking good !

[Fluke]

Hi Mark

Thanks so much for taking the time on the install guide. A top notch job and the finished result looks amazing!

If you need anything in the future please just yell.

Regards