News:

14/04/2022 - Summer is almost here!

Main Menu

Resolved: Bullet installation

Started by malta, August 18, 2011, 11:42:40 AM

Previous topic - Next topic

malta

I have fitted Bullets to my SH300. They look good.
I spliced one wire into a sidelight supply and then ran two wires from this wire to the Bullets via a terminal block. I used this method because when I tried running two wires from the sidelight supply along with bullet crimps inline, in case I needed to disconnect, the Bullets just wouldnt work.
Is what I have done OK? Any danger of the single wire carrying both loads overheating?

Fluke

Hi and welcome

It sounds like maybe a crimp wasn't connecting or maybe the polarity got reversed. Glad you are up and running though and all looks good. The load is extremely low so you are fine with a single wire powering both.

Regards