Purchased the CREE LED Aux Lights V3 along time ago and fitted to the Bike I had at the time a Suzuki GSX650F (BikeVis Gallery - https://www.bikevis.com/forum/index.php?topic=925.0 (https://www.bikevis.com/forum/index.php?topic=925.0)).
Now have changed my bike to a Honda NC700X (Manual Model) and have swapped the lights over.
I mounted them to my Hepco & Becker Bars using SW Motech Lamp Mounts. Wired together to a switch, powered from the ignition switch feed.
More Image Available Here - http://www.bikepics.com/members/slinkybiker/13nc700x/ (http://www.bikepics.com/members/slinkybiker/13nc700x/)
(https://www.bikevis.com/images/gallery/honda_nc700x_4/nc700x_1.jpg)
(https://www.bikevis.com/images/gallery/honda_nc700x_4/nc700x_2.jpg)
Hi
Many thanks for sharing and congratulations on the new bike, the lights match perfectly and a really tidy install! :)
Regards
Hi, from another NC owner (DCT).
I like the lights and the H & B bars - would like to get these myself but spending too much money on the bike at the moment - did you have any problems fitting the bars?
I have just started an install guide for front and rear bullets etc. on my NC in the Installation section.
Quote from: woodbar on September 28, 2013, 01:55:31 AM
I like the lights and the H & B bars - would like to get these myself but spending too much money on the bike at the moment - did you have any problems fitting the bars?
Hi, I got the Dealer to Fit the Engine Bars