Cree v3 wide angles on a 2007 Versys.
SWMotech 27mm brackets to fit the H&B crash bars
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_1.jpg)
Took the brackets of the lights. Attached them direct the the new brackets. One nut needed a few mm taken of with a dremel
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_2.jpg)
Bracket fitted on crash bar. Few rubber shims around it and one when the light attaches incase it tries to move
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_3.jpg)
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_4.jpg)
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_5.jpg)
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_6.jpg)
Heat shrink on the loose wires of the loom to protect them and keep then neat
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_7.jpg)
New switch on handlebars to be wired in
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_8.jpg)
Lights and switch wired back through. Few bits of trim removed, wires cable tied to main loom along side of tank
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_9.jpg)
Little 4 way fuse box fitted. Bit of, crimping and testing
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_10.jpg)
All wired in of a relay
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_11.jpg)
All looking good !
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_12.jpg)
(https://www.bikevis.com/images/gallery/kawasaki_versys_6/versys_13.jpg)
Hi Mark
Thanks so much for taking the time on the install guide. A top notch job and the finished result looks amazing!
If you need anything in the future please just yell.
Regards