BikeVis Support Forums

BikeVis Products => Technical Support => Topic started by: Wellerman on July 30, 2014, 08:01:42 PM

Title: Cree v2
Post by: Wellerman on July 30, 2014, 08:01:42 PM
I have had a set of v2 Crees for a couple of years which I love but today I noticed they didn't turn off when I turned the bike off, I have them wired straight to the battery. I am presuming the control box has given up the ghost but could it be anything else? I am thinking worst case scenario I could wire a switch in to the live feed to cut off the feed from the battery?
Title: Re: Cree v2
Post by: Fluke on July 31, 2014, 04:40:42 AM
Hi

Sorry to hear you are having trouble with your lights. It does sound like the controller could be at fault (unless you have a brand new battery fitted which can 'confuse' them due to lack of voltage drop on switch off)

A switch like you say in the red control box wire would give a good solution.

I'm afraid we have not stocked these for a couple of years now and have no spares available.

Regards
Title: Re: Cree v2
Post by: Wellerman on July 31, 2014, 07:48:32 AM
Hmmm interesting I have just fitted a brand new battery.....can the box be unconfused??
Title: Re: Cree v2
Post by: Fluke on August 01, 2014, 04:56:21 AM
Hi

Is it one of these new lithium batterys ?, the voltage change between on and off load is very small. A brand new battery could also cause same symptom.

I think you would need to fit that switch even as a temp measure.

Regards