BikeVis Support Forums

BikeVis Products => Technical Support => Topic started by: ronseal on November 17, 2016, 09:29:38 AM

Title: Switch to disable PodMod
Post by: ronseal on November 17, 2016, 09:29:38 AM
Hi,


Ive recently ordered the PodMod, along with Bullets v2 - I read its possible to add a switch to disable the PodMod, in your FAQs:

'Just wire up a simple switch between the- 'input ground' on the PodMod (grey wire)and- 'output ground' on the PodMod (black wire)When you connect these two together with the switch the Modulation is disabled, removing this connection restores Modulation'

Is it possible you could provide a diagram showing this physically. Apologies, Im not too electronically minded.

Regards
R
Title: Re: Switch to disable PodMod
Post by: Fluke on November 18, 2016, 05:08:07 AM
Hi

I'll drop you an email now

Regards
Title: Re: Switch to disable PodMod
Post by: NERVs on December 22, 2016, 11:03:27 PM
Fluke, please you send me the same diagram?
Title: Re: Switch to disable PodMod
Post by: Fluke on December 23, 2016, 05:44:19 AM
Hi and welcome

I've sent you an email.

Have a great Christmas and happy New Year

Regards
Title: Re: Switch to disable PodMod
Post by: Toptec2010 on October 16, 2018, 12:19:07 PM
Also grateful for that wiring email please? just about to order front and back pods and would like to be able to isolate the mod. Also if I'm brave enough i would like the rear red pods to come on brighter with the brakes, or upon deceleration (Tracer 700 twin and big torque so heavy engine braking) - can this all be combined ?if not I'll look at white bullets, pod mod and isolation switch for the front and red DRL and braking with deceleration activator ??? Many thanks Dave
Title: Re: Switch to disable PodMod
Post by: Fluke on October 23, 2018, 08:41:47 AM
Hi Dave

Sorry for the extreme delay in reply, we were away on leave.

I will email you now

Regards