Yamaha Diversion 600S Installation

[ross219uk]

Please note that cameras do not capture the brightness of the LED lighting used in our products


First decide where to fit your BikeVis LEDs, I girled out and mounted them in the bog stock position of under the head light.

Masked up the area and marked up where I was going to drill the holes for the wires



Drilled holes, removed masking tape and fed the wires through and mounted to the bodywork

First one mounted



Second set of wires being fed through



Both mounted up in position



Cut the wires to length and strip the ends down



Then feed into the power from the side light bulb



Don't do as I did and c*ck that last bit up, too embarrassed to say quite what I did but it involved a block connector ::)

The finished article



Sorry for the rubbish photos but they where taken with my workshop camera, i.e. £20 ebay special


Regards

Ross

[Fluke]

Thanks for the guide Ross, fantastic job!!!

Regards