Author Topic: Resolved: Bullet installation  (Read 2293 times)

malta

  • Newbie
  • *
  • Posts: 1
Resolved: Bullet installation
« on: August 18, 2011, 11:42:40 AM »
I have fitted Bullets to my SH300. They look good.
I spliced one wire into a sidelight supply and then ran two wires from this wire to the Bullets via a terminal block. I used this method because when I tried running two wires from the sidelight supply along with bullet crimps inline, in case I needed to disconnect, the Bullets just wouldnt work.
Is what I have done OK? Any danger of the single wire carrying both loads overheating?

Fluke

  • BikeVis Owner
  • Administrator
  • Hero Member
  • *****
  • Posts: 1536
Re: Bullet installation
« Reply #1 on: August 19, 2011, 06:37:03 AM »
Hi and welcome

It sounds like maybe a crimp wasn't connecting or maybe the polarity got reversed. Glad you are up and running though and all looks good. The load is extremely low so you are fine with a single wire powering both.

Regards